Jump to content
  • 0

How can I see mesh??


aen2424
 Share

Question

  • 0

Your LOD setting may be too low.  Use the Quick Preferences icon on your lower task bar and adjust the slider to about 3.5.  You may also want to check Advanced (CTRL + D) >> Debug Settings >> RenderMaxNodeSize.  A decent setting there is 65536 (the default).  If it is lower than that for some reason, increase it.

Link to comment
Share on other sites

7 answers to this question

Recommended Posts

  • 0

Your LOD setting may be too low.  Use the Quick Preferences icon on your lower task bar and adjust the slider to about 3.5.  You may also want to check Advanced (CTRL + D) >> Debug Settings >> RenderMaxNodeSize.  A decent setting there is 65536 (the default).  If it is lower than that for some reason, increase it.

Link to comment
Share on other sites

  • 0

That's actually nonsense! The default values for RenderVolumeLODFactor are 2.0 (low), 2.0 (medium), 2.0 (high) and 3.0 (ultra) in Firestorm. And those are even way higher than the default values from V3. If you can't see Mesh with the default values from Firestorm, you have some different issue, but definitely not an LOD problem.

Link to comment
Share on other sites

  • 0

Hmmmmm... That slider needs to be recalibrated then, and the wiki note needs to be changed. The slider maxes out at 4.0 and its midrange is 2.0. BTW, this is the second time in 24 hours that I've had the same question about mesh not showing up in Firestorm. Increasing the LOD factor solved the problem in the first case, but it may have been coincidence. I agree that it doesn't make much sense that LOD would be the solution, but something did.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...